Hill-Rom Advanta P1600, Service Manual

Page: 255 / 429

4.24 Hilow Head Limit Switch
Chapter 4: Removal, Replacement, and Adjustment Procedures
Advanta™ Bed Service Manual (man168ra) Page 4 - 71
4
NOTE:
The cable must be installed in the same manner.
10. Using the small wire cutters, cut the cable ties securing the cable (E).
11. Using the T25 Torx®
1
head screwdriver, remove the screw (I), and separate
the limit switch (J) from the hilow strap (O).
12. Lift the radial bracket (G) and the end of the hilow head drive screw
assembly.
13. Slide out the hilow head limit switch assembly.
Replacement
1. Lift up the hilow head drive screw assembly and install the hilow head
limit switch housing (E).
2. Using the T25 Torx® head screwdriver, secure the limit switch (J) to the
hilow strap (O) with the screw (I).
3. Route the cable (H) along the hilow strap (O) and secure it with cable ties.
4. Connect the cable (H) at the junction board.
CAUTION:
Do not over-tighten the limit switch mounting screws. Over-tightening
the mounting screws can cause the limit switch to malfunction.
5. Fasten the hilow limit switch housing (E) to the bed frame with the two
screws (D).
6. Secure the radial bracket (G) with the screw (F).
7. Assemble the hilow head limit switch assembly in the reverse order of
removal.
1. Torx® is a registered trademark of Textron, Inc.