HIKVISION RA4 Series, User Manual, Page: 64 / 102

Configuring PTZ Cameras 57
Configuring PTZ Cameras
Configuring Basic PTZ Settings
Settings for a PTZ camera must be configured before it can be used. Before proceeding,
verify that the PTZ and RS-485 of the DVR are connected properly.
To configure PTZ settings:
1. Enter the PTZ Configuration menu, shown in Figure 42 by going to Main
Menu > System Configuration > PTZ Configuration.
Figure 39. PTZ Configuration Menu
2. Select the Serial Settings tab.
3. Select the camera to configure in the camera drop down menu on the upper
left of the menu. If all cameras are to be configured with the same settings,
select
All Cameras from the list .
4. Configure PTZ settings, including those of Baud Rate , Data Bit , Stop Bit , Par-
ity , Flow Ctrl , Protocol and Address according to the parameters of the PTZ
camera(s).
5. Click the Save button to save current settings.
To test and verify PTZ settings:
1. Enter the PTZ Configuration menu, shown in Figure 42 by going to Main
Menu > System Configuration > PTZ Configuration.