HIKVISION PTZ Ultra Series, User Manual, Page: 105 / 139

Figure 6-19 Integration Protocol Settings
2. Check the Enable Hikvision-CGI checkbox and then select the authentication from the
dropdown list. Then you can access to the camera through the third party platform.
3. Check the Enable ONVIF checkbox to enable the function.
4. Click Add to add a new ONVIF user. Set the user name and password, and confirm the
password. You can set the user as media user, operator, and administrator.
5. Click Modify to modify the information of the added ONVIF user.
6. Click Delete to delete the selected ONVIF user.
7. Click to save the settings.
Network Service
Purpose:
You can control the ON/OFF status of certain protocol that the camera supports.
Notes:
Supported services vary according to camera models.
Keep unused function OFF for security concern.

WebSocket or WebSockets protocol are used for plug-in-free live view.
When you use Google Chrome 57 and its above version or Mozilla Firefox 52 and its
above version to visit your camera, you should enable WebSocket or Websokets
protocol. Otherwise, live view function is not usable.
If the camera uses HTTP, enable WebSocket.
If the camera uses HTTPS, enable WebSockets.

SDK Service and Enhanced SDK Service
If you want to add the device to the client software, you should enable SDK Service or
Enhanced SDK Service.
SDK Service: SDK protocol is used.
Enhanced SDK Service: SDK over TLS protocol is used. Communication between the
device and the client software is secured by using TLS (Transport Layer Security)
protocol.

TLS (Transport Layer Security)
The device offers TLS 1.1 and TLS 1.2. Enable one or more protocol versions according
to your need.
HTTP Listening
Purpose:
Alarm information can be sent to destination IP or Host via HTTP protocol.
Steps:
1.
Input destination IP or host name, URL, and port number.
2. Click Test to see if the service is available.
Note:
HTTP data transmission should be supported by the destination IP or Host.