17
User Manual of PanoVu Series Network Camera
2.
Set the HTTP port, RTSP port, HTTPS port and port of the camera.
HTTP Port
: The default port number is 80.
RTSP Port
: The default port number is 554.
HTTPS Port
: The default port number is 443.
Server Port
: The default port number is 8000.
3.
Click
to save the settings.
Configuring NAT (Network Address Translation) Settings
Purpose:
Universal Plug and Play (UPnP™) is a networking architecture that provides compatibility among
networking equipment, software and other hardware devices. The UPnP protocol allows devices to
connect seamlessly and to simplify the implementation of networks in the house and corporate
environments.
With the function enabled, you don͛t need to configure the port mapping for each port, and the
camera is connected to the Wide Area Network via the router.
Steps:
1.
Enter the NAT settings interface by
Configuration > Network > Basic Settings > NAT
2.
Check the
checkbox to enable the UPnP™ ͕ϢΣ̽χΊΪΣ΅
3.
Set the port mapping mode:
To port mapping with the default port numbers:
Choose
To port mapping with the customized port numbers:
Choose
And you can customize the value of the port No. by yourself.
Figure 2-7 Configure the Port No.
4.
Click
to save the settings.
2.2.2 Advanced Settings
Configuring SNMP Settings
Purpose:
You can use SNMP to get camera status and parameters related information.
Available from A1 Security Cameras
www.a1securitycameras.com email: [email protected]