HIKVISION PanoVu PT Series, User Manual, Page: 36 / 103

4.2 Set Preset
A preset is a predefined image position. For the defined preset, you can call the preset No. to view
the position.
Steps
1. Click to show the setting panel, and click .
2. Use the PTZ control buttons to move the lens to the desired position.
3. Select a preset number from the preset list, and click to finish the setting.
Note
Some presets are predefined with special command. You can only call them but not configure
them.
4. Repeat the steps above to set multiple presets.
Click the button to call the preset.
Click the button to delete the preset.
Note
You can delete all presets in Configuration → PTZ → Clear Config . Click Clear All Presets, and
click Save.
4.2.1 Special Presets
You can call the following presets with special demands to enable corresponding functions.
Preset No. Function Preset No. Function
34 Back to origin 93 Save manual limits
35 Call patrol 1 94 Remote reboot
36 Call patrol 2 102 Call patrol 5
37 Call patrol 3 103 Call patrol 6
38 Call patrol 4 104 Call patrol 7
39 Day mode 105 Call patrol 8
40 Night mode 106 Fan normally open
46 Day/Night Auto Mode 107 Fan normally close
92 Set manual limits 108 Fan temp ctrl
Target Capture Camera User Manual
27