Wireless Bridge (Client) User Manual
7
Chapter 4 Network Configuration
Basic Settings
Go to
→ Network → General to configure NIC type, IPv4 address, subnet mask, gateway
address, MAC address, and device port.
Figure 5-1 Network Configuration
Note
After the IPv4 address is reset, the device IP may not be in the same network segment as the
computer IP of the client, so it cannot be configured and managed. It is recommended to use the
SADP tool to plan the IP address of the device when the device is activated for the first time.
Advanced Settings
Go to
→ Network → Advanced Settings to configure DNS IP address.
DNS server address of your own computer or public address on the internet are both available.
Figure 5-2 Advanced Settings
Note
●
DNS auto-obtain is available only when you check Auto-obtain in Network → General.
●
It is recommended to configure both DNS1 and DNS2 address to prevent that one of the
addresses is invalid.
