By Client Software Add domain name to the client software. Refer to the client software
manual for specific adding methods.
8.4 Set IEEE 802.1X
IEEE 802.1X is a port-based network access control. It enhances the security level of the LAN/
WLAN. When devices connect to the network with IEEE 802.1X standard, the authentication is
needed.
Steps
1. Go to Configuration → Device Configuration → System → 802.1X .
Figure 8-4 Set IEEE 802.1X
2. Check Enable EEE 802.1X.
3. Select Protocol Type and EAPOL Version.
Protocol Type
If you use EAP-MD5, the authentication server must be configured. Register a user name and
password for 802.1X in the server in advance. Enter the user name and password for
authentication.
EAPOL Version
The EAPOL version must be identical with that of the router or the switch.
4. Enter User Name and Password registered in the server.
5. Confirm the password.
6. Click Save.
8.5 Set Image and Video Library
Set the interaction parameters of the device consistent with those of the image and video library
platform via the image and video library (1400) protocol, and register the device on the platform.
When the device generates alarm signals, the alarm information will be sent to the platform.
All-Rounder Bi-Spectrum Incident Detection Traffic Camera User Manual
48
