The lower the sensitivity is, the more sensitive the detection will be. For the detection
which is too sensitive (e.g., some fixed facilities, such as the bus station on the lane, are
detected as vehicles), you can adjust the sensitivity higher.
Influential Range X
If you do not want to adjust the total sensitivity, enter the vertical distance from the
possible mistakenly recognized area (such as the bus station) to the camera.
Note
The influential range of the sensitivity can be set every 50 m, and up to four areas can be
set.
Range X Sensitivity
You can adjust the sensitivity of each influential range independently.
Target Dwell Time
The dwell time of the vehicle. Set it as 0 when measuring the queue length.
Radar Prediction
Enable the function, and the radar will predict the target track which can be displayed on
the interface according to the detected coordinates.
Radar Detection Distance
It is the range of the radar track. The default value is 200 m. You can select the value to
adjust the radar track range.
Distance to Stop Line
It is the distance from the point on the ground just below the installed radar to the stop
line at the intersection. The targets detected in this range will be filtered.
Wave Band ID
0 to 4 stand for five frequencies. Set different wave bands for different radars in the same
scene to prevent the radars in the same wave band from influencing each other.
Course Angle Calibration
Adjust the course angle of the radar for target detection.
5. Click Save.
3.2 Set Radar Calibration
Calibrate radar after the radar detection parameters are set to display the targets detected by the
radar on the video.
Before You Start
Enable Rule Information in Configuration → Local Configuration .
All-Rounder Bi-Spectrum Incident Detection Traffic Camera User Manual
7
