HIKVISION IDS-2CD7A46G0-IZHSY 8-32, User Manual, Page: 52 / 90

Network Camera User Manual
UM Network Camera 072221NA 52
Chapter 7 Network Settings
7.1 TCP/IP
TCP/IP settings must be properly configured before you operate the device over a network. IPv4 and IPv6
are both supported. Both versions can be configured simultaneously without conflicting with each other.
Go to
Configuration → Network → Basic Settings → TCP/IP
for parameter settings.
• NIC Type : Select a NIC (Network Interface Card) type according to your network condition.
• IPv4
: Two IPv4 modes are available.
• DHCP : The device automatically gets the IPv4 parameters from the network if you check DHCP . The
device IP address is changed after enabling the function. You can use SADP to get the device IP
address.
The network that the device is connected to should support DHCP (Dynamic Host Configuration
Protocol).
• Manual : You can set the device IPv4 parameters manually. Input IPv4 Address , IPv4 Subnet Mask , and
IPv4 Default Gateway
, and click
Test
to see if the IP address is available.
• IPv6 : Three IPv6 modes are available.
• Route Advertisement
: The IPv6 address is generated by combining the route advertisement and the
device Mac address.
Route advertisement mode requires the support from the router that the device is connected to.
• DHCP
: The IPv6 address is assigned by the server, router, or gateway.
• Manual : Input IPv6 Address , IPv6 Subnet , IPv6 Default Gateway . Consult the network administrator for
required information.
• MTU : It stands for maximum transmission unit. It is the size of the largest protocol data unit that can be
communicated in a single network layer transaction.
The valid value range of MTU is 1280 to 1500.
• DNS (Domain Name Server) : Required if you need to visit the device with a domain name. It is also
required for some applications (e.g., sending e-mail). Set
Preferred DNS Server
and
Alternate DNS server
properly if needed.
• Dynamic Domain Name
: Check
Enable Dynamic Domain Name
and input
Register Domain Name
. The
device is registered under the register domain name for easier management within the local area
network.
NOTE: DHCP must be enabled for the dynamic domain name to take effect.