HIKVISION IDS-2CD7546G0-IZHSY 8-32 MM, User Manual, Page: 82 / 112

Network Camera User Manual
UM Network Camera User Manual 071421NA 82
1. Go to Configuration → Network → Advanced Settings → HTTPS.
2. Check
Enable
to access the camera via HTTP or HTTPS protocol.
3. Check Enable HTTPS Browsing to access the camera only via HTTPS protocol.
4. Select the Server Certificate.
5. Click
Save
.
NOTE: If the function is abnormal, check if the selected certificate is abnormal in
Certificate Management
.
9.14.4 Set QoS
QoS (Quality of Service) can help improve the network delay and network congestion by setting the data
sending priority.
NOTE:
QoS needs network support from devices such as a router and switch.
Steps
1. Go to Configuration → Network → Advanced Configuration → QoS.
2. Set Video/Audio DSCP, Alarm DSCP, and Management DSCP.
NOTE: The network can identify the priority of data transmission. The bigger the DSCP value,
the higher the priority. You must set the same value in the router while configuring.
3. Click Save .
9.14.5 Set IEEE 802.1x
IEEE 802.1x is a port-based network access control. It enhances the security level of the LAN/WLAN. When
devices connect to the network with IEEE 802.1x standard, the authentication is needed.
Go to
Configuration
→
Network
→
Advanced Settings
→
802.1x
, and enable the function. Set
Protocol
and
EAPOL Version according to router information.
Protocol
EAP-LEAP, EAP-TLS, and EAP-MD5 are selectable
• EAP-LEAP and EAP-MD5 : If you use EAP-LEAP or EAP-MD5, the authentication server must be
configured. Register a user name and password for 802.1x in the server in advance. Input the user
name and password for authentication.
• EAP-TLS: If you use EAP-TLS, input Identify, Private Key Password, and upload CA Certificate, User
Certificate, and Private Key.
• EAPOL Version : The EAPOL version must be identical with that of the router or the switch.
9.14.6 Control Timeout Settings