iDS-2CD7xxG0-xxxxx Network Bullet Camera User Manual
UM iDS-2CD7xxG0-xxxxx 021021NA
87
Face Filtering Time:
Time interval between the camera detecting a face and taking a capture
action. If the detected face stays in the scene for less than the set filtering time, capture will
not be triggered. For example, if the face filtering time is set as 5 seconds, the camera will
capture the detected face if the face stays in the scene for 5 seconds.
The face filtering time (longer than 0s) may increase the possibility of the actual capture
times less than the set value above.
Restore Default:
Click
Restore
to restore all the settings in advanced configuration to the
factory default.
Set Shield Region
The shield region allows you to set the specific region in which the set smart function rule is invalid.
Steps
1.
Select
Shield Region
.
2.
Click
to draw shield area. Repeat this step above to set more shield regions.
3.
Optional: Click
to delete the drawn areas.
4.
Click
Save
.
Road Traffic
Motor vehicles, non-motor vehicles, and pedestrians can be detected and captured when they enter the
set lane to realize rapid detection and comprehensive surveillance of the targets on road.
Only certain device models support this function.
Set Vehicle Detection
The vehicle that enters the set lane can be detected and the picture of the vehicle and its license plate
can be captured and stored. Alarm will be triggered and capture can be uploaded.
Before You Start
1.
Go to
Configuration
→
System
→
System Settings
→
VCA Resources
.
2.
Select
Road Traffic
.
Steps
1.
Go to
Configuration
→
Road Traffic
→
Detection Configuration
.
2.
Select
Vehicle Detection
as detection type.
3.
Check
Enable
.
4.
Select the lane number.