User Manual of Network Camera
89
Figure 6-51
Video Tampering Alarm
2.
Check
Enable Video Tampering
checkbox to enable the video tampering
detection.
3.
Set the video tampering area. Refer to
Task 1
Set the Motion Detection Area
in
Section 6.6.1.
4.
Click
Edit
to edit the arming schedule for video tampering. The arming schedule
configuration is the same as the setting of the arming schedule for motion
detection. Refer to
Task 2
Set the Arming Schedule for Motion Detection
in
Section 6.6.1.
5.
Check the checkbox to select the linkage method taken for the video tampering.
Audible warning, notify surveillance center, send email and trigger alarm output
are selectable. Please refer to
Task 3
Set the Alarm Actions for Motion Detection
in
Section 6.6.1.
6.
Click
Save
to save the settings.
6.6.3
Configuring Alarm Input
Steps:
1.
Enter the Alarm Input Settings interface:
Configuration > Advanced Configuration> Basic Event > Alarm Input:
Summary of Contents for I0D2400
Page 1: ...User Manual of Network Camera 1 User Manual UD 6L0201D1919A01 Network Camera ...
Page 147: ...User Manual of Network Camera 143 Figure 9 3 Overlay Content Settings ...
Page 166: ...User Manual of Network Camera 162 Figure A 1 2 Modify Network Parameters ...
Page 169: ...User Manual of Network Camera 165 ...