DS-PRI120 Security Radar User Manual
UM DS-PRI120 091720NA
8
Chapter 2 Activation
In order to protect personal security and privacy and improve the network security level, activate the device
the first time you connect the device to a network.
2.1
Activate Device via Client Software
Before You Start
•
Get the iVMS-4200 client software from the supplied disk or the official Website
. Install the software by following the prompts.
•
The device and the PC running the software should be in the same subnet.
1.
Run the client software.
2.
Enter
Device M
anagement → Device
in the Maintenance and Management list.
3.
Click
Online Device
.
4.
Check the device status from the online device list, and select an inactive device.
5.
Click
Activate
.
6.
Create and confirm the admin password of the device.
STRONG PASSWORD RECOMMENDED
−
We highly recommend that you create a strong
password of your own choosing (using a minimum of eight characters, including at least three of
the following categories: upper case letters, lower case letters, numbers, and special characters)
in order to increase the security of your product. We also recommend that you reset your
password regularly. Especially in high security systems, resetting the password monthly or weekly
can better protect your product.
Proper configuration of all passwords and other security settings is the responsibility of the
installer and/or end-user.
7.
Click
OK
to start activation. Device status will change to
Active
after successful activation.
8.
Edit IP address of the device.
1)
Select a device and click
on the online device list.
2)
Change the device IP address to the same subnet as your computer and set port number as 80.
3)
Enter the admin password of the device and click
OK
to complete modification.
9.
Optional:
Check the device on the online device list and click
Add
to add the device to the device list.
2.2
Activate via SADP
SADP is a tool to detect, activate, and modify the IP address of the device over the LAN.
