DS-PRI120 Security Radar User Manual
UM DS-PRI120 091720NA
15
Figure 4-5 Drag a Marker
4)
Hold to move the zone.
Figure 4-6 Move the Zone
5)
Click outside the zone to exit the zone editing mode.
To delete a zone, click
in the zone editing mode.
To edit the zone name and the zone type, click in the zone editing mode.
4.1.3
Add Trigger Line
Before You Start
Disarm the radar before adding trigger lines.
1.
Enter the IP address of the radar, and log in.
2.
Click
Radar
to enter the page.
3.
Click
Edit
to enter the editing mode.
4.
Click
Draw Trigger Line
. You can draw a Trigger Line or Dual-trigger Line.
Alarm is triggered by crossing the Trigger Line according to trigger line rule; alarm is
triggered only after crossing double lines of Dual-trigger Line according to trigger line rule.
Drawing a dual-trigger line that is too tortuous will cause a failure.
