User Manual of Mobile Digital Video Recorder
15
receiver in the front panel.
If there is no response after you press any button on the remote, follow the procedure below to troubleshoot.
Steps:
1.
Enter Menu > Other Settings > Display > Advanced Settings by operating the mouse.
2.
Check and remember device ID#. The default ID# is 255. This ID# is valid for all the IR remote controls.
3.
Press the DEV key on the remote control.
4.
Enter the device ID# in step 2.
5.
Press the ENTER button on the remote.
If the Status indicator on the front panel turns blue, the remote control is operating properly. If the Status indicator does not
turn blue and there is still no response from the remote, please check the following:
When the device ID# is 255, the Status indicator is off when device is controlled by an IR remote control.
1.
Batteries are installed correctly and the polarities of the batteries are not reversed.
2.
Batteries are fresh and not out of charge.
3.
IR receiver is not obstructed.
If the remote still can’t function properly, please change a remote and try again, or contact the device provider.
1.4
Starting Up and Shutting Down the Device
Two working modes are available for the mobile DVR. The connection of power cables and control interfaces varies from
the device working mode.
Vehicle ignition startup and time-delay shutdown
The mobile DVR starts up when the vehicle ignites and shuts down according to the pre-defined delay time after the vehicle
is off. The startup and shutdown of the device depend on the vehicle ignition signal.
Timing on/off
The mobile DVR starts up or shuts down automatically according to the pre-defined time and the device works separately
from the running status of the vehicle.
1.4.4
Vehicle Ignition Startup and Time-delay Shutdown
The vehicle ignition startup and time-delay shutdown are realized by the vehicle ignition switch, which includes positive
pole ignition switch (providing high level signal when the switch closes) and negative pole ignition switch (providing low
level signal when the switch closes). The wire connection of the device varies from different vehicle ignition switch.
For detailed time settings of time-delay shutdown, see
10.1 Configuring Startup and Shutdown
Please contact the vehicle manufacturer for the connection information of starting switch.
The vehicle ignition switch, also called car key, controls the startup and shutdown of the vehicle. Most of the cars
adopts positive pole ignition switch currently.
