HIKVISION DS-KH6320-WTE2, Configuration Manual, Page: 15 / 59

4) Optional: Enable Synchronize Language to synchronize the language of door
station with indoor station.
5) Tap OK to save the settings.
6. Tap Finish to save the settings.
2.3 Configuration Settings
Configuration settings is required before starting using the indoor station. It is
necessary to set the indoor station network, room No., linked devices, device time
display, and so on.
2.3.1 Set Indoor Station Network Parameters
Network connection is mandatory for the use of the indoor station. Set the network
parameters after activating the indoor station. Only when the IP address of the
indoor station is in the same network segment as other devices, it can work properly
in the same system.
Steps
Note
The default IP address of the indoor station is 192.0.0.64.
Two ways are available for you to set IP address: DHCP, and set IP address manually.
1. Tap Settings → → Configuration , and enter admin (activation) password.
2. Tap to enter the network settings page.
Figure 2-6 Network Settings
Video Intercom Indoor Station Configuration Guide
6