HIKVISION DS-KD8003-IME2, Configuration Manual, Page: 26 / 51

1.7.1 Local Network Configuration
Steps
1. Click Local Network Configuration to enter local network configuration page.
Figure 1-24 Local Network Configuration
2. Enter the Local IP Address, Subnet Mask, Default Gateway, Port and HTTP Port.
3. Click Save to enable the settings.
Note
•
The default port No. is 8000.
•
After editing the local network parameters of device, you should add the
devices to the device list again.
1.7.2 Linked Device Network Configuration
Before You Start
On the linked devices network configuration page, you can configure the network
parameters of master stations, SIP servers and management centers of the same
LAN. The devices can be linked to the door station and realize the linkage between
these devices.
Steps
1. Click Linked Network Configuration to enter linked network configuration page.
Module Door Station Configuration Guide
18