Note
• The cable bare part should be no more than 8 mm. If possible, wear an insulation cap at the end
of the bare cable. Make sure there’s no bare copper or cable after the wiring.
• The Terminal L and the Terminal N cannot be wired reversely. Do not wire the input and output
terminal reversely.
• To avoid people injury and device damage, when testing, the ground resistance of the
equipotential points should not be larger than 2 Ω
。
3.3 General Wiring
The picture displayed below describes the interconnecting cable's wiring diagram.
DS-K3G501 Series Tripod Turnstile Quick Start Guide
7