Note
• The cable bare part should be no more than 8 mm. It is suggested that you can immerse the
bare part into the liquid tin. If possible, wear an insulation cap at the end of the bare cable.
Make sure there’s no bare copper or cable after the wiring.
• The Terminal L and the Terminal N cannot be wired reversely. Do not wire the input and output
terminal reversely.
• To avoid people injury and device damage, when testing, the ground resistance of the
equipotential points should not be larger than 2 Ω
。
• Use the device in conjunction with an UPS.
4.3 Wire Interconnecting Cable
You should use interconnecting cables to connect the main lane board and the sub lane board for
components communication.
The picture displayed below describes the cable hole's position on the pedestals.
DS-K3B601SX Series Swing Barrier Quick Start Guide
12
