Face Recognition Swing Barrier Installation Guide_V1.1-20190215.docx
Product Support Team
11
5)
Install the cover on the round panel.
a) Move the cover on the round panel.
b) Rotate the cover and hide the hole on the cover and align the hole with one of the
four small parts on the round panel.
c) Secure the cover and the round panel with one supplied M2 screw.
Figure 9 Install cover
6)
Connect face recognition terminals and control board to the switch through UTP cable.
Note:
For face recognition terminal on master barrier, we can connect network cable to switch direct,
but for the device on slave barrier, it needs a network converter and an extension network cable, then
connect to the switch(see figure 10)
Figure 10 Terminals connected to switch
3. Configuration and Debug
3.1 Configure K3M200 barrier control board
1)
Install iVMS-4200 client software, activate and add K3M200 barrier control board to iVMS-4200
client software；
https://www.hikvision.com/en/Support/Downloads/Client-Software
2)
Open remote configuration of K3M200, go to system
RS-485, select 4 and 6 from drop-down list, ；
