HIKVISION DS-K3B601-L Series, Quick Start Manual

Page: 10 / 38

Swing Barrier
·
Quick Start Guide
2
Chapter 2 Installation
2.1 Disassembling Pedestals
Purpose:
Before installation, you should use the key to open the pedestals.
View the pictures below to find the locks and installation holes.
2.2 Installing Pedestals
Before you start:
Prepare for the installation tools, check the device and the accessories, and clear the installation
base.
Notes:

The device should be installed on the concrete surface or other non-flammable surfaces.

If the installation area is too close to the wall, make sure the distance between the pedestal
and the wall should be no more than 120 mm, or you cannot open the pedestal’s top panel.
Steps:
1.
Draw a central line on the installation surface for installing the center pedestal.
2. Draw another two parallel lines on each side of the central line for installing the other two
pedestals.
Note: The distance between the nearest two line is L+200 mm. L represents the lane width.
3. Drill holes on the ground according to the installation holes on the pedestals and insert the
expansion sleeves.
4. Bury interconnecting cables for pedestal communication.