HIKVISION DS-K1T605 Series, User Manual

Page: 65 / 107

5. Optional: Set the switch on the upper right corner to ON to
trigger the alarm output.
Configure Parameters for Lane Controller
After adding the lane controller to the client, you can configure its
parameters for passing through the lane.
Steps
1. Click Access Control Advanced Function Device Parameter to
enter Parameter Settings page.
2. In the device list on the left, select a lane controller and you
can edit the lane controller's parameters on the right.
3. Edit the parameters.
Passing Mode
Select the controller which will control the barrier status of
the device.
•If you select According to Lane Controller's DIP Settings, the
device will follow the lane controller's DIP settings to control
the barrier. The settings on the software will be invalid.
•If you select According to Main Controller's Settings, the
device will follow the settings of the software to control the
barrier. The DIP settings of the lane controller will be invalid.
Free Passing Authentication
If you enable this function, when both entrance and exit's
barrier mode is Remain Open, the pedestrians should
authenticate each time passing through the lane. Or an
alarm will be triggered.
Opening/Closing Door Speed
Set the barrier's opening and closing speed. You can select
from 1 to 10. The greater the value, the faster the speed.
Note
The recommended value is 6.
Audible Prompt Duration
Set how long the audio will last, which is played when an
alarm is triggered .
Note
0 refers to the alarm audio will be played until the alarm is
ended.
Temperature Unit
Select the temperature unit that displayed in the device
status.
4. Click OK.
9.4.2 Configure Remaining Open/Closed
You can set the status of the door as open or closed and set the
elevator controller as free and controlled. For example, you can
set the door remaining closed in the holiday, and set the door
remaining open in the specified period of the work day.
Before You Start
Add the access control devices to the system.
56