HIKVISION DS-K1T605 Series, User Manual

Page: 60 / 107

Display the card information when authenticating.
Display Person Information
Display the person information when authenticating.
Overlay Person Info. on Picture
Display the person information on the captured picture.
Voice Prompt
If you enable this function, the voice prompt is enabled in
the device. You can hear the voice prompt when operating in
the device.
Upload Pic. After Linked Capture
Upload the pictures captured by linked camera to the system
automatically.
Save Pic. After Linked Capture
If you enable this function, you can save the picture
captured by linked camera to the device.
Press Key to Enter Card Number
If you enable this function, you can input the card No. by
pressing the key.
Wi-Fi Probe
If you enable this function, the device can probe the
surrounding communication devices' MAC address and
upload the MAC address to the system. If the MAC address
match the specified MAC address, the system can trigger
some linkage actions.
3G/4G
If you enable this function, the device can communicate in
3G/4G network.
4. Click OK.
5. Optional: Click Copy to, and then select the access control
device(s) to copy the parameters in the page to the selected
device(s).
Configure Parameters for Door/Elevator
After adding the access control device, you can configure its
access point (door or floor) parameters.
Steps
1. Click Access Control Advanced Function Device Parameter .
2. Select an access control device on the left panel, and then click
to show the doors or floors of the selected device.
3. Select a door or floor to show its parameters on the right page.
4. Edit the door or floor parameters.
Note
• The displayed parameters may vary for different access
control devices.
• Some of the following parameters are not listed in the Basic
Information page, click More to edit the parameters.
Name
Edit the card reader name as desired.
51