5.3 System Configuration
5.3.1 General Configuration
Keep parameters as default value.
Note
The server enables device filter function by default, the server is accessible via its IP address only. If
you have configured port mapping, please disable the device filter function in order to access to
the server normally.
5.3.2 Service Configuration
It supports sending task analysis results to configured address
Before You Start
Obtain IP address, port or URL.
Steps
1. Go to System Management → System Configuration → Service .
Figure 5-6 Service Configuration Interface
2. Set SDK service or HTTP transmission protocol according to actual needs.
SDK Service
Send task analysis results to configured address via SDK protocol.
HTTP/HTTPS Transmission Protocol
Send task analysis results to configured address via HTTP protocol.
3. Click Save.
Intelligent Fusion Server User Manual
49
