Video Wall Controller • User Manual
4
Chapter 3 Web Configuration
Log in to the Web
After the device is activated, enter the IP address of the device in the browser. Enter the account
number and the password to log in to the Web of the device. The account number is admin and the
password is the activation password. The Web is used to configure the signal source, network,
system and other parameters of the device.
Configure Decoding Output
Introduces the parameter configuration of the output channels.
Enter Video Wall Configuration → Decoding Output. View the connected output channels in the
Output List.
Select a video wall on the right. Click
below the video wall. Set the row number and column
number of the video wall according to the requirement. Click OK.
Configure the Number of Row and Column
Drag the output channel on the right to the video wall. The signal source will be displayed on the
video wall.
Configure Signal Cable
Configure the signal connection of the sending card and the receiving card between different
cabinets based on the site conditions.
Enter Video Wall Configuration
→
Decoding Output. Select LED sending card in the Output List
(Example of naming the LED sending card: LEDSendCard_Board19_1). Right-click and select Signal
Cable Configuration.
Summary of Contents for DS-C30S-04HI
Page 1: ...0 Video Wall Controller User Manual...
Page 38: ...0 UD26426B...
