HIKVISION DS-9608NI-I8, User Manual, Page: 173 / 243

User Manual of Network Video Recorder User Manual
172
12.1 Configuring Array
Purpose:
RAID (redundant array of independent disks) is a storage technology that combines multiple disk drive
components into a logical unit. A RAID setup stores data over multiple hard disk drives to provide enough
redundancy so that data can be recovered if one disk fails. Data is distributed across the drives in one of several
ways called "RAID levels", depending on what level of redundancy and performance is required.
The NVR support the disk array which is realized by the software, and RAID0, RAID1, RAID5 and RAID 10 are
supported. You can enable the RAID function on your demand.
Before you start:
Please install the HDD(s) properly and it is recommended to use the same enterprise-level HDDs (including model
and capacity) for array creation and configuration so as to maintain reliable and stable running of the disks.
Introduction:
The NVR can store the data (such as record, picture, log information) in the HDD only after you have created the
array or you have configured network HDD (refer to Chapter13.2 Managing Network HDD ). Our device provides
two ways for creating array, including one-touch configuration and manual configuration. The following flow
chart shows the process of creating array.
Figure 12. 1 RAID Working Flow
12.1.1 Enable RAID
Purpose:
Perform the following steps to enable the RAID function, or the disk array cannot be created.