HIKVISION DS-9500 Series NVR, User Manual, Page: 60 / 76

User Manual of DS-9500 Series NVR
57
Adding Array
Step3: When the array configuration is complete, click
the OK button on the pop-up Attention box to finish
the settings.
Note:
1) After completion of One-touch Configuration, the
device will create 1 array and 8 virtual disks
automatically. And the array capacity will be
equally allocated to each virtual disk.
2) By default, the foreground initialization is used
when the configuration is finished. And the hard
disk can be used only after the initialization is
complete.
Step1: Enter the RAID Settings menu by clicking
Config > Remote Config >RAID Configuration.
Step2: Select the physical HDD from the list, and click
the Create button to enter the Create Array interface.
Step3: Edit the Array Name, and set the RAID Level to
RAID 0, 1, 5 or 10. Select the physical HDD to be used
for array creation.
Step4: Click the OK button to continue the creation of
array.
Step5: In the pop-up Attention box, click the Yes
button to finish the array creation.
Note:
During the creation of array, corresponding
error message box will pop up if the estimated array
capacity is not enough for creating the array.