HIKVISION DS-9500 Series NVR, User Manual, Page: 18 / 76

User Manual of DS-9500 Series NVR
15
2.2 Network Configuration by Hyper Terminal
Enter Hyper Terminal
Click “Start”->“Programs”->“Accessories”->“Communications”->“Hyper Terminal”->“HK”, then the Hyper
Terminal interface will appear as figure below. Type “Enter”, and the prompt “[root@dvrdvs/]#” will appear which
means connection between RS232 interface of PC and RS232 interface of NVR is established successfully by
Hyper Terminal. The following operation commands are to accomplish the parameters setup in the prompt.
Figure 2.2.1
Commands Utilities
helpm Console help command is used to print common commands, show as Figure 2.2.1.
getIp Show the current IP address of NVR. Command format: getIp “Enter”.
setIp
Setup NVR IP address. Command format: setIp IP: mask
e.g. setIp 192..168.1.11:255.255.255.0
getPort Show the current port of NVR. Command format: getPort “Enter”.
setPort
Setup NVR port. Command format: setPort Port
e.g. setPort 9000
getGateway Show current NVR gateway address. Command format: getGateway “Enter”.
setGateway
Setup NVR gateway. Command format: setGateway Gateway
e.g. setGateway 192.168.1.1