Digital Video Recorder User Manual
182
There are two 10M/100M/1000M NIC cards provided by the DS-8100HQHI-F/N and
DS-7300/8100/9000HUHI-F/N series devices, and it allows the device to work in the
Multi-address, Load Balance and Net-fault Tolerance modes for DS-8100HQHI-F/N and
Multi-address and Net-fault Tolerance for DS-7300/8100/9000HUHI-F/N.
Multi-address Mode:
The parameters of the two NIC cards can be configured independently.
You can select LAN1 or LAN2 in the NIC type field for parameter settings.
You can select one NIC card as default route. And then the system is connecting with the
extranet the data will be forwarded through the default route.
Net-fault Tolerance Mode:
The two NIC cards use the same IP address, and you can select
the Main NIC to LAN1 or LAN2. By this way, in case of one NIC card failure, the device will
automatically enable the other standby NIC card so as to ensure the normal running of the
whole system.
Load Balance Mode:
By using the same IP address and two NIC cards share the load of the
total bandwidth, which enables the system to provide two Gigabit network capacity.
The valid value of MTU is from 500 to 1500.
If the DHCP server is available, you can check the checkbox of
DHCP
to automatically obtain
an IP address and other network settings from that server.
Step 4
After having configured the general settings, click the
Apply
button to save the settings.
12.2 Configuring Advanced Settings
12.2.1
Configuring PPPoE Settings
Purpose
The DVR also allows access by Point-to-Point Protocol over Ethernet (PPPoE).
Step 1
Enter the
Network Settings
interface.
Menu > Configuration > Network
Step 2
Select the
PPPoE
tab to enter the
PPPoE Settings
interface.
Figure 12-2
PPPoE Settings Interface
Step 3
Check the
Enable
PPPoE
checkbox to enable this feature.
Step 4
Enter
User Name
and
Password
for PPPoE access.
