DS-7108HI-S series Net DVR User Manual
15
Chapter4 Basic Operation Guide
4.1 Power on
Note: Please make sure that the power supply matches DVR and DC adapter is
connected correctly. Before switching DVR on, please connect one monitor through VOUT
or VGA interface. Otherwise, you cannot see graphic user interface and operate.
If [POWER] lamp is off, please do as follows:
Step1: Connect power supply correctly;
Step2: Switch on the power button on the rear panel.
When DVR is started, [POWER] lamp is green. If the HDD is not installed or detected, the
information “No Disk A
×
” will be seen in the lower right corner of the preview screen.
4.2 Preview
DVR will enter the preview mode after started.
On preview screen, you can see date, time, and camera icon.
Set system date and time in “Camera” → “Date OSD” menu; Change camera name in
“Camera” menu, please refer to 5.5
On the screen, you will see record and alarm status of each camera. Shown as Fig. below,
these two kinds of status will alternate automatically.
Press [A] key to display or hide the camera status bar.
Fig. 4.1 Recording Status
