DS-6700HFHI/V Series Network HD Encoder User Manual
20
Figure 5. 3
Picture Capture Succeeded
The saving path for the captured pictures can be set at the
Configuration > Local Configuration
page.
The image is saved as a JPEG file on your computer.
5.3
Operating PTZ Control
Before you start:
1.
Make sure the encoder is connected with the camera/dome which supports PTZ function. Connect the
R+
and
R
-
terminals of the pan/tilt unit or speed dome to RS-485 D+ and RS-485 D- terminals of the DS-6700
respectively
.
2.
The baud rate, PTZ control and address configured in the
RS-485 Settings
interface
(
Configuration >
System Settings > RS485
), as shown in Figure 5.4, must be the same with the parameters of the connected
pan/tilt unit or speed dome.
Figure 5. 4
RS-485 Settings
5.3.1
Operating PTZ Movement
In live view mode, you can use the PTZ control buttons to realize pan/tilt/zoom control of the camera lens.
There are 8 directional buttons (up, down, left, right, upper left, upper right, bottom left, bottom right) on the
display window when the mouse is located in the relative positions.