User Manual of DS-6600 Audio/Video Encoder
18
Chapter 3 Network Parameters
Configuration
Purpose:
If you don’t know the IP address of the encoder and this is not the first time you use the encoder, you can use
SADP (IP finder) software or the Serial port tools to find out the IP address of the encoder and to configure the IP
address or other network parameters of it. It is recommended to change the default IP address for the first time to
use it.
This chapter aims to tell the procedures of using the SADP software and the Hyper Terminal Software to find and
configure the IP address and other parameters of the device.
Note:
For the first-time user, the default user name of DS-6600 is
admin
, and password is
12345
. And the default IP
address is
192.0.0.64
.
3.1 Hyper Terminal Setup
The common method is to connect encoder and PC with serial line, run Hyper Terminal and modify parameters
with serial command. Please connect the RS-232 port of encoder with the COM port of PC directly, power on the
encoder and PC and follow the steps:
Step1: Enter Hyper Terminal.
Click “Start”-> “Programs”->”Accessories”-> “Communications”->”Hyper Terminal” in Windows system, and
the dialogue box below will appear:
Figure 3.1 Create New Connections
