HIKVISION DS-3WR12C, User Manual, Page: 123 / 147

WiFi Router • User Guide
115
To access the configuration page, log in to the web UI of the router, and navigate to
Administration > WAN Parameters .
When the Ethernet cable is not damaged and connected to the WAN port properly, but Ethernet
cable disconnected is still shown on the Internet Settings page, you can try to change the WAN
Speed to 10 Mbps full-duplex or 10 Mbps half-duplex to solve the problem. Otherwise, keep the
default settings.
Change the WAN speed
WAN speed parameter description
Auto-negotiation
It indicates that the speed and duplex mode are determined through
the negotiation with the peer port.
100 Mbps full
duplex
It indicates that the WAN port is working at the speed of 100 Mbps,
and the port can receive and send data packets at the same time.
10 Mbps half
duplex
It indicates that the WAN port is working at the speed of 10 Mbps, but
the port can only receive or send data packets alternately.
10 Mbps full
duplex
It indicates that the WAN port is working at the speed of 10 Mbps,
and the port can receive and send data packets at the same time.
100 Mbps half
duplex
It indicates that the WAN port is working at the speed of 100 Mbps,
but the port can only receive or send data packets alternately.
WAN Speed Description