Note:
Drill the cable hole, when adopting the ceiling outlet
to route the cable.
3.
Route the cables through the cable hole, or the side
opening.
4.
Attach the bracket to the ceiling, and secure the
camera with supplied screws.
Figure 2-9
Secure the Camera to the Ceiling
Note:
The supplied screw package contains self-tapping
screws, and expansion bolts.
For cement wall/ceiling, expansion bolts are
required to fix the camera. For wooden
wall/ceiling, self-tapping screws are required.
5.
Connect the corresponding power cord, and video
cable.
6.
Power on the camera to check whether the image
on the monitor is gotten from the optimum angle. If
not, loosen the trim ring to adjust the position.
Pan Position
[0° to 360°]
Tilt Position
[0° to 90°]
Rotation Position
[0° to 360°]
Trim Ring
Figure 2-10
3-Axis Adjustment
2.3
Installation of Type III Camera
2.3.1
Ceiling/Wall Mounting without Junction Box
Before you start:
The installation of ceiling mounting and wall mounting
are similar. Following takes ceiling mounting as an
example.
Steps:
1.
Disassemble the camera by rotating the camera to
align the notch to one of the line, as shown in the
figure below.
Notch
Figure 2-11
Dissemble the Camera
2.
Pry the mounting base by using a flat object, for
example, a coin.
A Coin
Figure 2-12
Pry the Mounting Base