2
Installation
Before you start
Make sure that the device in the package is in good
condition and all the assembly parts are included.
Make sure that all the related equipment is power-off
during the installation.
Check the specification of the products for the
installation environment.
Check whether the power supply is matched with
your power output to avoid the damage.
Make sure the wall is strong enough to withstand
three times the weight of the camera, and the
mount.
If the wall is cement, insert expansion bolts before
installing the camera. If the wall is wooden, use
self-tapping screws to secure the camera.
If the product does not function properly, contact
your dealer or the nearest service center. Do NOT
disassemble the camera for repair or maintenance by
yourself.
2.1
Installation of Type I Camera
2.1.1
Ceiling/Wall Mounting without Junction Box
Before you start:
The installation of ceiling mounting and wall mounting
are similar. Following takes ceiling mounting as an
example.
Steps:
1.
Paste the drill template (supplied) to the place
where you want to install the camera.
2.
Drill the screw holes and the cable hole (optional)
on the ceiling according to the drill template.
Template
Side Opening
Screw Hole
Ceiling
Outlet
Figure 2-1
Drill Template
Note:
Drill the cable hole, when adopting the ceiling outlet
to route the cable.
3.
Route the cables through the cable hole, or the side
opening.
4.
Attach the bracket to the ceiling, and secure the
camera with supplied screws.
Figure 2-2
Secure the Camera to the Ceiling