HIKVISION DS-19A08-F/Kx, User Manual, Page: 84 / 157

Control Panel User Manual
84
3.2.21 LCD Backlight off
For Disabling the LCD backlight, see the command below:
{*} +{8} + {#}
3.2.22 Pacing
The pacing function is used for debugging; see the command below:
{password} + {*} + {6} + {0} + {#}

The function of pacing is only available under the status of disarming and
non-fault of the zone. The system will do auto-arming in the pacing mode
without reporting any CID log. The siren will start warning after the alarm
is triggered and stop warning if the alarm is dismissed.

If the zone is disarmed, it will exit the pacing mode automatically.
3.2.23 SMS Arming/Disarming
The control panel supports SMS arming/disarming, the command is shown
below:

Away arming for the partition
{#} +{121} +{#} +{Partition No.} + {#}

Instant arming for the partition
{#} +{122} +{#} +{Partition No.} + {#}

Stay arming for the partition
{#} +{123} +{#} +{Partition No.} + {#}

Partition disarming
{#} +{120} +{#} +{Partition No.} + {#}

Partition alarm clearing
{#} +{100} +{#} +{Partition No.} + {#}
The partition No. is with three digits. for example. If the partition No. is 1.
The command of partition alarm clearing is {#} +{100} +{#} +{001} + {#}