HIKVISION 7200HFI-SV Series, User Manual, Page: 60 / 254

User Manual of Digital Video Recorder
59
Note: Sensor alarm is not supported by DS-7200HFI/HWI-SV series. The interface of the device are subject to
the actual model.
5.1 Configuring Encoding Parameters
Purpose:
By configuring the encoding parameters you can define the parameters which affect the image quality, such as
transmission stream type, the resolution and so on.
Before you start:
1. Make sure that the HDD has already been installed. If not, please install a HDD and click to
initialize it. (Menu>HDD>General)
Figure 5. 1 HDD- General
2. Check the storage mode of the HDD
1) Click Advanced to check the storage mode of the HDD.
2) If the HDD mode is Quota , please set the maximum record capacity and maximum picture capacity.
For detailed information, see Chapter 11.5 Configuring Quota Mode .
3) If the HDD mode is Group , you should set the HDD group. For detailed information, see Chapter
5.8 Configuring HDD Group for Recording and Capture .
Steps :
1. Enter the Record settings interface to configure the encoding parameters:
Menu>Record>Parameters
Figure 5. 2 Record Parameters