HIKVISION 7200HFI-SV Series, User Manual, Page: 147 / 254

User Manual of Digital Video Recorder
146
Figure 9. 4 Network Settings Interface for DS-7600HI-ST
Note: In network settings interface: The FTP setting is supported by DVR series only. The Dual NIC (network
interface card) is not supported by DS-7200HFI(HWI)-SV & 7600HI-ST series. We use the interface of
DS-9100HFI-ST series (unless otherwise stated) as example to describe the following settings.
2. Select tab.
3. In the General Settings interface:
For DS-7200HFI(HWI)-SV & 7600HI-ST series, you can configure the following settings: NIC Type,
IPv4 Address, IPv4 Subnet Mask, IPv4 Gateway, MTU and DNS Server.
For other series, you can configure the following settings: Working Mode, NIC Type, IPv4 Address, IPv4
Subnet Mask, IPv4 Gateway, MTU and DNS Server.
If the DHCP server is available, you can check the checkbox of DHCP to automatically obtain an IP
address and other network settings from that server.
Note: The valid value range of MTU is 500 ~ 9676.
4. After having configured the general settings, click to save the settings.
Working Mode: There are two 10M/100M/1000M NIC cards provided by the device, and it allows the device
to work in the Multi-address, Load Balance and Net Fault-tolerance modes.
Multi-address Mode: The parameters of the two NIC cards can be configured independently. You can select
LAN1 or LAN2 in field for parameter settings.
You can select one NIC card as default route. And when the system is connecting with the extranet the data will
be forwarded through the default route.