HikRobot ID5000 Series, User Manual

Page: 64 / 107

ID5000 Series Smart Code Reader User Manual
55
Figure 8-38 Select Output Signal
8.4.2 Enable Line Inverter
The level inverter function allows the device to invert the electrical signal level of an I/O line, and
meets requirements of different devices for high or low electrical signal level.
You can go to
I/O Control Settings → Output → Line Out Inverter to enable it.
Note
The Line Out Inverter function is disabled by default.
Figure 8-39 Enable Line Out Inverter
8.4.3 Set Event Source
The device supports outputting different trigger signals according to the event source you select.
Click
I/O Control Settings → Output → Line Out Activation Event to select event source.
The device supports following event sources, including Acquisition Start Active , Acquisition Stop
Active , Frame Burst Start Active , Frame Burst Stop Active , Exposure Start Active , Soft Trigger
Active , Hard Trigger Active , Counter Active , Timer Active , No Code Read , Read Success , and Light
Strobe Long , Compare Success , and Compare Fail .
Note
● Off refers to no event source.
● Some event sources support the function of trigger output cache, and you can go to Feature
Tree → Trigger and IO Control > Line Out Cache to enable it.