ID2000 Series Smart Code Reader User Manual
59
8.4.3 Enable External Trigger Mode
In the external trigger mode, the device acquires images via external signals like software signal
and hardware signal. You have 2 methods to enable the external trigger mode:
●
Click
I/O Control Settings
→
Input
→
Trigger Mode
, and select
On
as
Trigger Mode
.
●
In the live view page, click
to enable the external trigger mode.
Set and Execute Software Trigger Mode
In software trigger, the software sends trigger signal to the device via I/O interface to acquire
images.
Steps
1. Click
I/O Control Settings
→
Input
→
Trigger Mode
.
2. Select
On
as
Trigger Mode
.
3. Select
Software
as
Trigger Source
.
4. Click
Execute
in
Trigger Source
to send trigger commands.
You can also enter
Auto Trigger Time
, and then enable
Enable Auto Trigger
to let the client
software automatically send trigger signal to device according to the interval you set.
Figure 8-26 Set and Execute Software Trigger Mode
Set and Execute Hardware Trigger Mode
Steps
1. Click
I/O Control Settings
→
Input
→
Trigger Mode
.
2. Select
On
as
Trigger Mode
.
3. Select the specific line as
Trigger Source
according to actual demands.
Note
For the vari focal device, you can select customized lines as
Trigger Source
4. Set
Debounce Time
and
Line Out Trigger In Polarity
according to actual demands.