CoaXPress Area Scan Camera
·
User Manual
33
9.2.2 Enable Strobe Signal
The strobe signal is used to directly output I/O signal to external devices when camera’s event
source occurs.
Click Digital IO Control, select different output events as Line Source, and enable Strobe Enable.
The specific line source may differ by camera models.
Figure 9-3
Enable Strobe
For specific Line Source, please refer to following table for details.
Table 9-1
Line Source Description
No. Name
Description
1
Exposure Start Active
It refers to output one I/O edge signal when starting exposure.
2
Acquisition Start Active
It refers to output one I/O edge signal when starting acquisition.
3
Acquisition Stop Active
It refers to output one I/O edge signal when stopping acquisition.
4
Frame Burst Start
Active
It refers to output one I/O edge signal when starting triggering and
acquiring images under Burst mode.
5
Frame Burst End Active
It refers to output one I/O edge signal when stopping triggering and
acquiring images under Burst mode.
6
Frame Trigger Wait
The camera is currently waiting for a frame start trigger.
Summary of Contents for CoaXPress
