English
29
TROUBLESHOOTING
Use the inspections in the table below if the tool does not operate normally. If this does not remedy the problem, consult your
dealer or the HiKOKI Authorized Service Center.
Power tool
Symptom
Possible cause
Remedy
Tool doesn’t run
Trigger switch is in OFF position
Turn on the switch.
The power cord is not plugged in properly.
Plug the power cord correctly.
Tool suddenly stopped
Tool was overburdened.
Get rid of the problem causing the
overburden.
Cannot be tilted
The clamp lever has not been loosened.
Loosen the clamp lever and then tilt the tool.
After adjusting the loosened component,
make sure to tighten it once again.
Sawblade is dull
The sawblade is worn down or missing
teeth.
Exchange with a new sawblade.
Bolt is loose.
Tighten the bolt.
The sawblade has been installed in reverse. Install the sawblade in the correct direction.
Cannot cut with precision
The operation parts of the tool are not fully
fi
xed.
Fully
fi
x the clamp lever and bevel lock
knob.
Material cannot be
fi
xed in the correct
position.
Remove any foreign material from the fence
or turntable.
In some cases, proper position cannot be
fi
xed due to a curve in the material.
Try to
fi
x a
fl
at surface with the fence or
turntable.
Motor head cannot be
lowered
Blade guard locking lever is not released.
Release the blade guard locking lever and
then lower the motor head.
00Book̲C8FSHG̲WE,NE.indb 29
00Book̲C8FSHG̲WE,NE.indb 29
2019/08/05 10:38:01
2019/08/05 10:38:01
