38
Enforcer V10 Programming Guide
9.
Site Name – Using the numerical keys to enter the site name from ‘System
Displays’ Press
.
Please note: Make sure that the SIM card in use is enabled for GPRS data
and that the correct APN settings have been entered for your network
(See ‘COMMUNICATIONS’).
Connecting to the InSite software:
1.
Click on ‘Roving Dial customer’ (or hold Ctrl and press the F10 key).
2.
Click on the ‘Dial Out Mode’ drop down list and select ‘Cloud’
3.
Enter the ‘System ID’ of your Control Panel (See ‘Set Up Downloading’ in the panel’s Engineer menu)
4.
Enter the ‘System Password’ (as entered in ‘Set Up Downloading’ in the Engineer menu)
5.
Leave the UDL security level at ‘low’ for the initial connection test in the ‘System Security Level’ field.
6.
Enter the Engineer code as used on the Control Panel you are trying to connect to.
7.
Enter the ‘Site Name’ as entered in the panel ONLY if it was entered on the panel, to otherwise, leave this blank.
8.
In the ‘Enter Customer In Database As’ field, simply give the panel you are connecting to an appropriate name.
9.
Click ‘Dial’. If the connection is successful, the Cloud Icon will become blue. A dialogue box will appear asking
if you would like to create a customer, click ‘yes’ to continue.
10. The system is now successfully connected to the Insite UDL Software. Now select ‘Data from Panel’ to
download panel settings and proceed to make changes remotely.
Set Up Downloading via RS232
1.
Press
or
to scroll to ‘SET UP DOWNLOADING?’. Press
.
2.
‘Download By’ : Use
[
or
]
to scroll to ‘RS232’. Press
.
3.
Enter a UDL password. This will need to be referenced in the InSite software.
Press
.
4.
Enter a Site Name. This will need to be referenced in the InSite software. Press
.
Please note: If a ‘Site Name’ is set up on the panel, the UDL ‘Site Name’
must be exactly the same, otherwise the connection will fail.
Connecting to the InSite software:
1.
To set up the COM port associated to ‘modem’, open the software, click on ‘Configuration’, choose ‘Modem
Settings’ and select the ‘RS-232’ option
2.
Make sure that the serial COM used by the UDL software is set the same as in youR PC.
E.g. Control Panel -> Device Manager -> Ports (Typical Windows PC)
3.
Make sure that the RS-232 icon (at the bottom of the screen) has turned green
