User Manual of DS-1100KI Network Keyboard
106
Note:
1.
Corresponding error message will appear on the screen when you perform wrong operation.
2.
All programmed parameters will be cleared if you press the Num + PATROL keys again in the process of
setting the patrol.
•
Setting a Patrol by Input Channel
Steps:
1.
Input the Num + CAM keys to select the input channel.
2.
Press the SET key to enter the settings interface.
3.
Press the Num + PATROL keys to enter the patrol settings interface.
4.
Input Num and press the ENTER key to set the preset number, stop time and speed respectively.
5.
Press the SET key again to finish the patrol settings.
Note:
1.
It is invalid to input the 0+CAM keys in the current operation mode.
2.
Corresponding error message will appear on the screen when you perform wrong operation.
8.4.5 Calling a Patrol
Select the output monitor or window and the keyboard is capable of automatically connecting with its
corresponding camera. Press the PATROL key on the keyboard to call the programmed patrol. You are also
allowed to directly select the camera and then press the PATROL key to realize patrol callup.
•
Calling a Patrol by Output Channel
Steps:
1.
Input the Num + MON keys to select the output channel.
2.
Input the Num + WIN keys to select the display window.
3.
Press the Num + PATROL keys to call the programmed pattern.
Note:
This operation is valid only when the patrol function is supported by the connected camera/dome.
