Highlight MAGNUM 1300 TB-U, Operation Manual

Page: 14 / 53

MACHINE SET-UP
It is very important to read all instructions before undertaking any of these steps. The
following steps should help achieving a safe and quick machine set-up.
1. Your Magnum® Case Sealer comes pre-assembled and ready for operation. Set
up the machine where it will not be subject to moisture or damage to its power
cord.
2. Although the Magnum® Case Sealer is pre-assembled, the casters allow for some
height adjustment. To adjust height, loosen “B” screw on all four casters (see
figure below), lift machine to desired height and retighten “B” screw.
NOTE:
Nut “A” fixes the caster in place.
3. The rollers are detachable. They are held to the machine by four holding screws
attached to the machine body. To detach the roller tables, loosen (complete
removal is not necessary) all four holding screws, then lift the table straight up
and pull out. The table has four slots fitting over the screws (see figure below).