Page 52 of total 94 pages
IP address:
set IP address of DVR. Press up and down direction key and press number key can
change value of IP address.
Subnet mask:
set subnet mask of the IP address. Press up and down direction key and press number
key can change value of subnet mask.
MAC:
display MAC address of DVR.
Gateway:
set gateway of the IP address. Press up and down direction key and press number key can
change the value of IP address.
HTTP:
set port number for IE browser accessing. Press directly number key input.
Server:
it is used to set whether starts using server host, while starts using server host, DVR will
register periodically its information to server host.
IP
refers to
IP
of server host, press directly
number key to input
；
Server port
, press directly number key to input
；
Interval time
refers to
automatic registration interval time of DVR to server host, press directly number key to input.
PPPoE:
it is used to set whether starts using PPPoE protocol dial up and access internet.
IP
is a
dynamic IP address obtained after network access by using PPPoE protocol.
User name
and
password
refer to user name and password provided by ISP, press directly number key to input.
NAT:
network address switch, it is used in standard method of an address field mapping to other
address field, NAT will permit a special institute host in Internet to be transparently connected to the
host in public domain, without the requirement of internal host that has registered Internet address.
Press directly number key to input.
Dynamic domain:
it is used to set whether starts using dynamic domain, it is to realize analysis from
stationary domain to dynamic IP. Press directly number key to input applied domain name on
domain
name
.
User name
and
password
under
dynamic domain
are user name and password when apply
the domain name, which is effective only when PPPoE dials up internet .
Media port
: it is used to set audio and video streaming port, default is 6050. Press directly number
key to input.
CMD port:
it is used to set command control port, default is 5050. Press directly number key to
input.
NOTE
When starts using PPPoE dial up internet, after input user name and password, click save exit,
enter again network figure one minute later, then can see assignation dynamic IP address in PPPoE IP
edit
；
In addition, while restarting device, it will redial automatically and obtain new IP address. When
change and save the settings of network, it will pop up the started dialog window, see the following
Summary of Contents for HY-8004HC
