6
www.EJF.com
WINGS CONTINUED
PICTURE ON LEFT: Check the Aileron and Rudder hinge slots to make sure the hinges fit properly. If needed, use and
exacto knife open up further just make sure to get them in the middle of the leading edge of the Aileron or Flap.
PICTURE ON RIGHT: I am checking the Hinge Slot or hole in the HET F-16 Aileron.
PICTURE ON LEFT: When the hinges are glued, I measure the pushrod to mark the servo location. Measure your servo
wire and add servo extension wire to reach your receiver.
PICTURE ON RIGHT: When gluing servos on a model airplane, I like to protect them using tape, I used a single piece of
tape that is able to wrap around the servo at least twice. I glued the Aileron servos directly to the wing. This example is
the HET-F16.
