High End Systems studio color, User Manual

Page: 63 / 114

Chapter 3 Menu System 3-13
Introduction
Menu System
3
Mode Menu
Use the following subsections to perform the functions contained within the
M O d E
menu.
Selecting Operational Mode 1
Reserved for future use.
Selecting Operational Mode 2
Reserved for future use.
Cross-Loading Fixtures
Studio Color can cross-load software from one fixture to all other fixtures on the
same link (32 fixtures per link). To cross-load software, complete the following
procedure:
1. Disconnect the data cable between controller and the first fixture.
2. Hold the <
MENU
> button on the master fixture until the display changes to
A d d R
.
3. Using the up and down buttons, scroll down to the
M O d E
field and press
the <
ENTER
> button.
4. Using the up and down buttons, scroll down to the
X L d
field and press
the <
ENTER
> button. The master fixture will upload its software to all
connected fixtures on the link. The slave fixtures will display
U P L d
during the process.
Notes: if the fixture(s) take longer than one minute to reset after an upload, turn off
the fixture(s) and repeat the procedure. Cross-loading can also be
instigated by holding down both arrow keys on the master fixture when it is
turned on.