HID FARGO DTC 5500LMX, User Manual

Page: 19 / 74

May 2017 PLT-02496, Version: 1.2
Page 2-5 Installation and Setup Procedures
2.5 Installing Blank Cards into the Input Card Hopper
The FARGO DTC5500LMX Card Printer is capable of printing multiple feed cards (batch mode).
1. Load the cards with the print side down and (if applicable) the magnetic strip up and towards
the front of the printer.
Information: Do not run the cards with a contaminated, dull or uneven surface through the
Printer.

Printing onto such cards may lead to poor print quality and can greatly reduce the life of
the printhead.

Card types include PVC or PVC finish.

Cards eject into the output hopper or reject hopper.

Each input hopper holds 100 cards.

Certain types of smart card chips are raised slightly above the cards surface, which may
result in poor color transfer.
Design the card with white space surrounding the chip.
2. Open the input card hopper door.
3. Press the card hopper load lever down until the card tray locks into place.
4. Load up to 100 cards into the hopper with the print side down.
Note:
If using cards with a magnetic stripe, the magnetic stripe should be loaded with the
stripe up and to the front of the Printer.
5. Close the input card hopper door to release the lever to the printing position.