background image

OPERATING INSTRUCTIONS

Please read the instruction manual carefully before 
operating the appliance and keep the instruction manual properly.

USER'S MANUAL

PROFESSIONAL  WIRELESS 

MICROPHONE  SYSTEM

contact details

WEB:www.hiberr.com
Facebook:  https://www.facebook.com/hiberr.mic

E-Mail: [email protected]

PROBLEM

POSSIBLE CAUSE

SOLUTION

The unit is dead

No receiption 

The hand mic is 

not working

Distorted sound

No"RF" signal 

on the receiver

Noise / Distortion

*Piece suddenly goes dead

*No power supply

*Transmitter is not switched ON

*Transmitter and receiver donot work though all 

LEDs andconnections seem ok

*2x1.5V battery inserted wrong

*2x1.5V battery is weak

*Input Gain of the Amplifier orMixer very high

*Gain on the hand mic is toohigh

*Transmission distance between the transmitter 

andreceiver is very far

*Defective or broken antenna

*Transmitter and receiver have different frequencies

*Two transmitters using the same frequency 

interference from other transmitter

*Battery of the transmitter isweak

*Switch off the other transmitters

*Avoid using two transmitter of the same frequency

*Replace the battery

*Reduce the distance betweentransmitter and receiver

*Check antenna and replace it if necessary

*Make sure the transmitter and receiver are of the same 

frequency

*Reduce the gain in the Mixer or Amp and adjust the volume 

control on the transmitter

*Reduce the gain in the Hand mic

*Reverse the Polarity

*Reverse the battery

*Check the power supply

*Connect power adapter

*Switch ON the transmitter

*Make sure that the transmitter and receiver are on the same 

frequency

*Receiving antennas are not pulled out, extend the antennas

PW-20

AF

AF

RF

FREQ.

CHA

RF

MHz

ASC

UHF

10

20

30

40

dB

10

20

30

40

dB

RF

AF

AF

RF

510.0-545.0

FREQ.

CHB

MHz

510.0-545.0

MH

Z

CHB

527.0

ON

MH

Z

CHB

527.0

ON

PW-20

SPECIFICATIONS

SYSTEM:

① Frequency preparation: PLL
② Frequency range: Optional (60 frequencies for selection )
③ AF Response:80Hz~15Khz(±3dB)
④ Distortion:≤1%
⑤ Operating Temperature Range: -10℃ ~+40℃

TRANSMITTER :

① RF output power: 11mW (10mW~30mW)

 

Spurious rejection:<-50dB

 

Battery: 2*1.5V AA (common)

                    2*1.2V AA(rechargeable)

①Cartridge: dynamic

RECEIVER :

① Sensitivity: 12dBμv(80dB S/N)

 

Sensitivity adjust range: 12~32dBμv 

 

Audio output level: 0~0.5V/600Ω

Audio output:0~0.5V/5k

TROUBLESHOOTING

IMPORTANT NOTICE

·

 

Please kindly read and keep this manual carefully.

·

 

Take attention of the full items show on the manual.

·

 

Must cut off the power while cleaning the equipment.

·

 

It is better using the original accessories, such as adapter and cable.

·

 

While it is thunderstorm weather or don't use the equipment for a long 

time, please unplug the receiver from equipment.

·

 

Do not place the receiver and transmitter near the source of heat, such as 

radiator, oven and also keep them away from water.

CLEANING AND MAINTENANCE

·

 

Do not spill the liquid into the device, otherwise it will 

damage the electronic components of the device. 

·

 

Disconnect the power before cleaning

·

 

Clean the device with a soft cloth.

·

 

No solvent or cleaner is allowed for cleaning.

®

Reviews: